18W DC Tips (Optional)

With Over-current, over-voltage, short-circuit, over-temperature protection to protect circuit.

The input power shall be less than 0.1W at 115 or 230Vac input.

Ripple voltage is 150mV p-p (Full load 1.5A) measured methods: Performed by 20MHz bandwidth in oscilloscope Applied 0.1uF ceramic capacitor and 10uF electrolytic capacitor across output connector terminals Measured at the end of DC cable. The environment temperature is 25℃ or aging test after 15 minutes.

Measured at 115Vac or 230Vac input voltage, Average efficiency can reach energy star VI (85%) standard.

Primary to Secondary: 3000Vac /10mAMax / 60S (when safety testing);
Primary to Secondary: 3300Vac /5mAMax / 3S (when production).

100MΩ min. between primary to secondary add 500Vdc test voltage.

0.25mA maximum, at nominal AC input voltage and frequency.

2 hours at 40°C maximum, Normal input voltage, rated load.

Wall-mounted type. US-pin. 2 Conductors, < Live. Neutral > Wall-mounted type. BS-pin. 2 Conductors, < Live. Neutral >
Wall-mounted type. EU-pin. 2 Conductors, < Live. Neutral > Wall-mounted type. AU-pin. 2 Conductors, < Live. Neutral >

1M for wall mount type and 0.76M for desktop as above described. Test times for each 1 times, a total of 6 times； The horizontal surface consists of hardwood at least 13mm thick,the plug can be bend, and scratch, but the structure should not be damaged, and can work normally.

0℃ to +40℃ 10%RH to 90%RH Storage Temperature and Relative Humidity -25℃ to +70℃ 5%RH to 95%RH non-condensing

When the power supply is operating within the limits of this specification the MTBF shall be at least 50000 hours at 25℃ (MIL-HDBK-217F).

10 to 300Hz sweep at a constant acceleration of 1.0G(Breadth: 3.5mm) for 1Hour for each of the perpendicular axes X, Y, Z.